Quick contact
MSDS
PEROXAN CU-40 M
Hydroperoxide / Polymerization / Curing / Crosslinking
Cumyl hydroperoxide
44%,
Solution in promotor
PEROXAN CU-40 M is used for the curing of unsaturated polyester resins and vinylester resins.
TDS UP
« back
PEROXAN CU-40 M
CAS No.:
80-15-9
Appearance:
Active oxygen assay:
Density at 20°C:
clear liquid
appx. 4.6%
1.03 g/cm³
Maximum storage temperature (Ts max):
Minimum storage temperature (Ts min):
Storage stability as from date of delivery:
30°C
0°C
6 months
Keep packaging tightly closed in a well ventilated place at indicated storage temperature. Keep away from reducing agents e.g. amines, acids, alkalis, heavy metal compounds (e.g. accelerators, driers, metal soaps). Never weigh out in storage room.
Oxidizing agent. Decomposes violently under the influence of heat or by contact with reducing agent. Never mix with accelerators.
|
Flash point: SADT: |
>SADT°C 80°C |
|
|
The SADT (Self Accelerating Decomposition Temperature) is the lowest temperature at which a self accelerating decomposition may occur.
|
Schlavenhorst 71 D-46395 Bocholt Germany |
Phone: +49 (0)2871 / 99 02-0 Fax: +49 (0)2871 / 99 02-50 www.pergan.com |
HPUPCL/004/1020 Page 1 of 2 |
PEROXAN CU-40 M
Hydroperoxide / Polymerization / Curing / Crosslinking
PEROXAN CU-40 M is used for the curing of vinylester resins in combination with cobalt accelerator.
PEROXAN CU-40 M can successfully be used instead of generally applied ketone peroxides like PEROXAN ME-50 LA with the following features:
- No "gassing" after the peroxide is mixed in the preaccelerated viylester resin. This phenomenon is very often recognized as a disadvantage of the ketone peroxides in vinylester resins.
- The use of an amine accelerator is in general not necessary to achieve a good cure.
- A fast cure in thin coatings and laminates up to a thickness of approx. 6 mm
- A low peak exotherm in thick laminates
Depending on working conditions, the following peroxide and accelerator dosage levels are recommended:
PEROXAN CU-40 M: 2,0 to 3,0 phr
PERGAQUICK C12 X (Cobalt, 1%): 0,5 to 3,0 phr
Please refer to the material safety data sheet (MSDS) for information concerning safe storage, use and handling of PEROXAN CU-40 M. This information should be thoroughly reviewed prior to acceptance of this product. The MSDS is available for downloading at www.pergan.com or through contacting Pergan directly.
|
Schlavenhorst 71 D-46395 Bocholt Germany |
Phone: +49 (0)2871 / 99 02-0 Fax: +49 (0)2871 / 99 02-50 www.pergan.com |
HPUPCL/004/1020 Page 2 of 2 |
Material Safety Data Sheets
Here you can download safety data sheets according to Regulation (EC) no. 1907/2006.
Safety Data Sheets are an important source of information on chemicals, such as identity of the product,
occurring hazards, transport, safe handling and measures for prevention in case of danger